Zenith-data-systems MT2000 Uživatelský manuál stáhnout pdf (Strana 98)

5-10

Upgrades and Options

To remove the board support panel:

Observe the safety and ESD precautions listed at the

beginning of this chapter.

Remove the left side panel (as viewed from front).

Remove four screws from the board support panel

(Figure 5-3). Save the screws for reattaching the

board support panel.

Remove panel by pulling it out of the chassis. Set

the board support panel aside.

Figure 5-3. Removing Board Support Panel

POWER

STATUS

DISK

Removing board support panel

A Support panel

B Screws (four total)

(structural details of panel not

shown here)

Installing the Board Support Panel

Place the board support panel in position so that the

rear edge of the processor/memory board fits snug

against the panel (Figure 5-3).

Secure the internal panel with four screws.

Reinstall the exterior side cover.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 204 205

Žádné komentáře

Zenith-data-systems MT2000 Uživatelský manuál Strana 98