Zenith-data-systems MT2000 Uživatelský manuál stáhnout pdf (Strana 110)

5-22

Upgrades and Options

Figure 5-8. Non-Volatile Memory Location

Replacing the Non-Volatile Memory

Notice: Observe static precautions. Use an antistatic

wrist strap.

1. Power off the system and remove the side panel as

described earlier in this chapter.

2. Using a IC removal tool or a small pointed tool,

gently pry up each end of the non-volatile memory

and pull it straight up out of its socket (Figure 5-8).

3. Orient the new chip over its socket so the dot is

properly oriented. Carefully insert the chip into its

socket connectors.

4. Press down on the chip until it is firmly seated in its

socket.

5. Replace the side panel and turn on the system.

6. Run the BIOS SETUP and SCU to restore proper

configuration settings.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 204 205

Žádné komentáře

Zenith-data-systems MT2000 Uživatelský manuál Strana 110